SCOTLAND COUNTY, NC - CEMETERIES - Sessoms Family Cemetery ==================================================================== USGENWEB NOTICE: In keeping with our policy of providing free information on the Internet, data may be used by non-commercial entities, as long as this message remains on all copied material. These electronic pages may NOT be reproduced in any format for profit or for presentation by other persons or organizations. Persons or organizations desiring to use this material for purposes other than stated above must obtain the written consent of the file contributor. The submitter has given permission to the USGenWeb Archives to store the file permanently for free access. This file was contributed for use in the USGenWeb Archives by: John Wilson MaddogAberdeen@webtv.net ======================================================================= Sessoms Cemetery My wife's ancestors are buried on the Mutt Mckoy Farm. Originaly was the J. P. Morgan Farm. This is the direction from Aberdeen, NC. Travel highway US #1 South, leaving Moore Co. and go approximately 12 miles. There will be a factory on your left, that was called Brown Molding, but now it is Mill Source M W Windows. Once you pass this factory, turn on the first dirt road on your left. This is called the Old Laurel Hill Road. Once you get on this road you will be leaving Richmond Co. and entering into Scotland Co. Travel this dirt road quite a ways until you run into the black top ( paved road ). Once you get on the paved road , you will come to a sharp curve. A double- wide trailer will be on the left side. The cemetery is in the curve on the right and is hard to see, because it is grown up so badly. The cemetery has many sunken graves and one headstone: Eva Grant daughter of Harley & Annie Grant. b. 3-20-1922 d. 6-24-1922. There are approximately 10 to 15 other graves there with old unreadable funeral home markers and big rocks to mark the graves. There were several Sessoms with no stones, and there are some Grants with stones. If you need any further help, just contact me at my e-mail address. John Wilson